ISO 10816 Mechanical vibration — Evaluation of machine vibration by measurements on non-rotating parts —Part 5 – Machine sets in hydraulic power generating and pumping plants

ISO 10816

Mechanical vibration — Evaluation of machine vibration by measurements on non-rotating parts —Part 5 – Machine sets in hydraulic power generating and pumping plants

Provides guidelines for application of bearing housing vibration evaluation criteria measured under normal operation conditions at the bearings, bearing pedestals or housings of the main machine sets in hydraulic power generating and pumping plants, given in terms of both steady-state running vibration and any amplitude changes occurring in these steady values. Applicable to machine sets in hydraulic power generating and pumping plants where the hydraulic machines have speeds from 60 r/minute to 1800 r/minute, shell or shoe type sleeve bearings and a main engine power of 1 MW and more.

Contents: Foreword
Introduction
1 Scope
2 Normative references
3 Machine arrangements
4 Measurement procedures and conditions
4.1 General
4.2 Measurement type
4.3 Measurement locations and directions
4.4 Measurement equipment
4.5 Operational conditions
5 Evaluation
5.1 General
5.2 Criterion I: Vibration magnitude
5.3 Evaluation zone limits
5.3.1 Turbine operating conditions
5.3.2 Pump operating conditions
5.3.3 Special conditions
5.3.4 Axial vibration
5.4 Criterion II: Change in vibration magnitude
5.5 Operational limits
5.5.1 General
5.5.2 Setting of ALARMS
5.5.3 Setting of TRIPS
5.5.4 Special operating conditions
5.6 Supplementary procedures/criteria
5.7 Evaluation based on vibration vector
information
Annex A (normative) Evaluation zone boundaries
Annex B (informative) Special features of bearing housing
vibration of hydraulic machine sets
Annex C (informative) Analysis procedure and applied
regression technique
Bibliography

파일 다운로드